DCS Valves, Orifices, and Manifolds

Orifice for infrared burners with starter hole #63 if you need to drill the hole. Includes brass elbow with 1/4” compression fitting.

NOTE: If you need the orifice pre-drilled for Natural Gas or LP Gas, during check-out, in the message box, please state that you need the orifice drilled for Natural Gas #55 or for LP Gas #59.

Part Number: CLA-VB0245
Dimensions: 3 3/8” x 17 1/4”
Material: stainless steel and ceramic
Weight: 0.3

CLA-VB0245 fits these 122 DCS models:
27 27ABQR 27BQR 27BQRL 27BQRN 27DBQR 27FSBQR	36A-BQAS 36A-BQR 36A-BQRS 36A-BQS 36DBQ 36DBQAR 36DBQR	48 48BQ 48BQAR 48BQR 48BQRS 48DBQAR 102 more models...

Brass hood orifice with #72 starter hole and 1/8” x 22 threading for use with valves 37700, 37800, and 38800. Must be drilled to proper drill size.

If you would like us to drill the orifice(s) for you, there is a single $15 fee for this service, which will be added to the order when processed. Please tell us the number of burners in your grill and the total BTUs of your grill (less side burner and rotisserie burner, if any). BTU rating information can usually be found on the grill's CSA certification tag, located somewhere on the grill. Please furnish this, along with any other information you deem relevant, in the Message to CLA box during checkout.

Part Number: 37900
Dimensions: 0 3/4” x 0 1/2”
Material: brass
Weight: 0.1

Brass valve for DCS.

• For LP and natural gas grills (see below)
• Off position D-Value: 12 o'clock
• Stem diameter: 8mm
• Orifice not included

NOTE: There is a set screw in the stem that allows this valve to be used in both LP or natural gas grills. The valve is shipped with the screw set in LP position. Turn the screw counterclockwise about seven turns for natural gas use.

Part Number: 30171
Dimensions: 3 7/16” x 1 5/16”
Material: brass
Weight: 0.3

30171 fits these 237 DCS models:
27 27ABQ 27ABQR 27BQ 27BQR 27BQRL 27BQRN	27DBQ 27DBQR 27FSBQ 27FSBQR 36 36A-BQ 36A-BQAR	36A-BQARS 36A-BQAS 36A-BQR 36A-BQRS 36A-BQS 36BQ 217 more models...