Nexgrill 730-0891R Grill Parts

Stainless steel burner for Nexgrill model 730-0891R.

Part Number: 16411
Dimensions: 13 3/4” x 4 1/4”
Material: stainless steel
Weight: 0.7

Stainless steel cooking grid for Nexgrill model 730-0891R. Sold as a set of two (2).

Part Number: 5S752
Dimension Front-to-Back: 15”
Dimension Side-to-Side: 21 1/2”
Material: stainless steel clad wire
Weight: 7.3

Stainless steel Flame Tamer for Nexgrill model 730-0891R. Sold individually.

Part Number: 90831
Dimension Front-to-Back: 13 3/16”
Dimension Side-to-Side: 5 15/16”
Material: stainless steel
Weight: 1.2

Ignition module switch for spark generators that accept wired remote (button) trigger switches. Fits our spark generator part numbers 03322, 03332, 03344, 03352, 03356, 03387 and 03388.
Includes:

• Push-button ignition module switch with two male spade connectors on back
• Two 20” wires with female spade connectors
• One plastic mounting nut

For more information about ignition systems and components, please see article Ignition 101 in our help center.

Part Number: 03152
Dimensions: 17 3/4” x 1”
Weight: 0.1

Battery powered ignitor/spark generator for Surefire electronic ignition systems using remote button/trigger.

• 1.5 volt
• Has two (2) spark outlets (male spade connector)
• Has two (2) male spade connectors for trigger (button) part #03152 (sold separately)
• Uses a single AA battery (not included)
• Requires 7/8” mounting hole

NOTE: The battery cap is not a push button. The ignitor is fired by a remote button/switch.

For more information about ignition systems and components, please see article Ignition 101 in our help center.

Part Number: 03322
Dimensions: 2 5/8” x 2”
Weight: 0.5

Ground wire required when replacing spark generator for a valve-triggered electrode with a remote switch-triggered spark generator. 03621 plugs into one switch inlet; ring connects to generator neck; switch wire plugs into the other generator switch inlet

For more information about ignition systems and components, please see article Ignition 101 in our help center.

Part Number: 03621
Dimensions: 1 1/8” x 1 1/8”
Weight: 0.1

Ignition electrode.

For more information about ignition systems and components, please see article Ignition 101 in our help center.

Part Number: 04460
Dimensions: 4 5/16” x 1 1/2”
Weight: 0.2

Round 2 3/8” diameter heat indicator, includes one wing nut and one locking nut.

• Requires minimum 3/8” mounting hole
• Single 1 3/8” probe
• Threaded portion of probe stops at 1/2” from base
• See photo for details

Part Number: 00012
Dimensions: 2 3/8” x 2 3/8”
Weight: 0.1

Venturi Tube 12” Brush. Recommended by all grill manufacturers. Specially designed flexible brush to clean venturis of spider webs and other obstructions that can cause flashback fires. Stainless steel.

Part Number: VTC-B
Material: stainless steel
Weight: 0.3